H-RCSD-2B RESIDENTIAL REMOTE CONTROL SWITCHING DEMONSTRATOR 

The Hampden Model H-RCSD-2B Residential Remote Control Switching Demonstrator provides a complete trainer showing a state-of-the-art home wiring system via programmed or manual remote control of lighting and appliances. The Model H-RCSD-2B Residential Remote Control Switching Demonstrator is based on the Lutron Caseta Home Controls using the various Caseta Smart Bridge Components designed to simulate a residential house wiring system including a complete comprehensive training program.

H-RPT-1 RESIDENTIAL PIPING TRAINER 

The Hampden Model H-RPT-1 Residential Piping Trainer is designed to demonstrate a series of modern waste flushing systems. The H-RPT-1 Residential Piping Trainer consists of three modern flushing system: Single Flush Flushometer, Dual Flush Flushometer, and Pressure Assist Water Closet.​

H-ETST-1 ELECTRONIC TELEPHONE SYSTEM TRAINER 

The Hampden Model H-ETST-1 Electronic Telephone System Trainer was developed for student training and troubleshooting of state-of-the-art electronic telephone systems. This trainer permits the student to move from classroom theory to hands-on troubleshooting with current technologies. The Model H-ETST-1 is provided with eight instructor switched faults located in a metal enclosure with locking access cover, and three non-switched faults.
Options:
H-ETST-1T Electronic Telephone Installers Tool Kit Option

H-MFA-3C FIRE ALARM DEMONSTRATOR 

The Hampden Model H-MFA-3C Fire Alarm Demonstrator is a fully functioning fire alarm system which can be utilized to present the student with a variety of common installation and operational features. The trainer is a composite of basic equipment usually associated with residential and commercial layouts, including: Main Control Panel, Alarm Signal Device, Heat Detector, Smoke Detector, City Circuit Monitor, Pull Station, Remote Annunciator Panel, and Auxiliary Function Panel.

HAMPDEN ENGINEERING CORPORATION


​sales@hampden.com

P.O. Box 563

​East Longmeadow, MA 01028

​(Toll Free) 800-253-2133 or 888-HEC-CORP

Local: 413-525-3981

​Fax: 413-525-4741​

H-BACT-3 BURGLAR ALARM CIRCUITS TRAINER 

The Hampden Model H-BACT-3 Burglar Alarm Circuits Trainer contains all of the actual components found in standard residential and industrial security systems. The unit provides the student with experience in designing, wiring, checking out, and troubleshooting burglar alarm circuits.​

H-RCSD-4 HOME AUDIO, VIDEO AND SURVEILLANCE CONTROL WIRING DEMONSTRATOR 

The Hampden Model H-RCSD-4 Home Audio, Video and Surveillance Control Wiring Demonstrator provides a complete trainer showing a state-of-the-art home wiring system. The Hampden Model H-RCSD-4 is based on Leviton® components. Designed to simulate a modern high-tech residential wiring system. The system takes the student through the complete installation, from making connection to programming the controls. Instructor insertable faults are included to teach troubleshooting techniques and skills.

H-PPST-1 PIPING/ PIPEFITTERS SYSTEM TRAINER 

The Hampden Model H-PPST-1 Piping/ Pipefitters System Trainer provides the student with a "hands-on" trainer for piping. The student will learn the necessary methods of connecting and running metal/iron piping, plastic piping, copper tubing, and hydraulic hose. Each material has its own particular methods used in plumbing.

H-GFP-2A GROUND FAULT PROTECTION DEMONSTRATOR 

The Hampden Model H-GFP-2A Ground Fault Protection Demonstrator is a fully functioning ground fault protection system that provides the student a model for examining some common installation and operational procedures. The system used on the H-GFP-2A represents different zones of protection demonstrating both single-phase (GFICB breaker) and three-phase (GFR shunt trip breaker) application.

HEE-FONT FIBER OPTICS NETWORK TRAINER 

The Hampden Model HEE-FONT Fiber Optics Network Trainer is a versatile program for all age groups from early middle school through vocational school. This system uses a modular approach which eliminates the long hours of curriculum research/preparation and equipment assembly. The HEE-FONT is a stand-alone system - laser is not required.

H-EH-2A ELECTRIC HEAT DEMONSTRATOR 

The Hampden Model H-EH-2A Electric Heat Demonstrator contains various types of electric heaters and control devices that might be found in either home or industry. The following individual components are provided: radiant ceiling lamp, radiant ceiling heater, radiant ceiling panel, forced air wall heater, radiant baseboard heater, low voltage transformer relay, low voltage thermostat and line voltage thermostat. These components allow for the application of electrical heating techniques of wiring, control, and operation of various types of electrical heating devices.

H-RET-2 RESIDENTIAL ELECTRICITY TRAINER 

The Hampden Model H-RET-2 Residential Electricity Trainer consists of electrical components and instrumentation for demonstration and practical exercises in electrical circuits and measurements.

PST-1 PLUMBING TRAINER 

The Hampden Model PST-1 Plumbing Trainer is used to demonstrate an environmentally friendly toilet flushing system. Utilizing gray water, i.e., water drained from a sink, the vanity tank will fill and pump the gray water into the water storage tank of a standard toilet. The gray water will be used to flush the toilet instead of using clean water.​

HEE-TNC TELECOMMUNICATION NETWORK CABLING 

The Hampden Model HEE-TNC Telecommunication Network Cabling course provides the tools and equipment needed to learn about modern PC network topologies. The course - designed for secondary and post secondary students - overviews network topologies and investigates the basics of cabling with emphasis on: standards, grounding, preparing cable ends, testing cables and wireless networks. Hands-on experiments include: pulling cables through a conduit, punching down cables to a 110 punch block, using a patch panel and installing common network connectors onto cables.
Options:
HEE-TNC-RK Replacement Kit
MCI-1000 Mobile A-Frame Stand
H-444-1 Digital Multimeter

construction trades technology

H-EM-2D EMERGENCY LIGHTING DEMONSTRATOR 

The Hampden Model H-EM-2D Emergency Lighting Demonstrator is a fully functioning emergency lighting system compactly arranged to present the student with some of the most common installation and operational features. The trainer is a composite of basic equipment usually associated with commercial and industrial layouts and typical of those encountered by the service technician, including: load center, control console, nickel-cadmium battery, battery charger, distribution panel, remote control alarm, Exit sign fixture, flood light and wall fixture. The H-EM-2D is capable of a number of configurations and is not strictly limited to the equipment supplied with the demonstrator.
Options:
H-EM-2D-FP Electrical Fault Package Option

H-MCP-3A CLOCK SYSTEMS DEMONSTRATOR 

The Hampden Model H-MCP-3A Clock Systems Demonstrator introduces the student to a variety of installation and operational features normally associated with an electronic master clock system. It is a complete fully functional clock system representative of the systems found in schools, hospitals, industrial and office applications. It features a synchronous indicating clock, minute impulse clock, AC vibrating bell, DC vibrating bell, AC single stroke chime, DC single stroke chime, AC remote buzzer and master time center.​

H-RCSD-3A RESIDENTIAL/ COMMERCIAL REMOTE CONTROL SWITCHING DEMONSTRATOR 

The Hampden Model H-RCSD-3A Residential/ Commercial Remote Control Switching Demonstrator provides a complete trainer showing a state-of-the-art building wiring system control of lighting and appliances via programmed or manual remote. The Model H-RCSD-3A is based on the LonWorks® Control System using the various building automation components designed to simulate a residential/commercial wiring system, including a complete comprehensive training program. These devices freely exchange operating system information utilizing an internally accepted and LonMark® Interoperability Association controlled open protocol.

H-MCI-1000-WSB-1 WIRING SERVICE BOARD TRAINER 

The Hampden Model H-MCI-1000-WSB-1 Wiring Service Board Trainer is ideal for learning wiring skills in Electrical Shops with limited space. The following manuals are furnished with the trainer: The National Electrical Code, Blue Print Reading, and Instructor’s Guide. Also included with the Model H-MCI-1000-WSB-1 is "Get Wired" computer software with topics such as: Home Electricity Basics, Adding New Wiring, High Tech Wiring, and The Data Highway.

H-RIG-1C RIGGING SYSTEMS TRAINER 

The Hampden Model H-RIG-1C Rigging Systems Trainer is designed to teach the techniques of safely moving loads of various shapes, sizes and types. The Hampden Rigging System contains a variety of lifting and moving devices to allow the student to learn the proper methods of moving loads safely.

www.hampden.com/logo

Copyright 2019  CLICK WebDesigns